| Step | | Procedure & Parts & Tools |
| 1 |
|
LOCATE THE TANK
|
| 2 |
|
REMOVE THE SCREWS ON THE CONTROL PANEL. FLIP THE CONTROL PANEL OVER AND DISCONNECT THE WIRES.
| Screwdriver-phillips |
|
|
| 3 |
|
RAISE THE TANK LID TO OPEN THE TANK. EMPTY THE BLADDER BAG (SOLUTION) INTO THE RECOVERY TANK. DRAIN THE RECOVERY TANK.
|
| 4 |
|
REMOVE THE HOSE CLAMP TO DISCONNECT THE SOLUTION FILTER HOSE.
| Screwdriver-flat tip |
|
|
| 5 |
|
LIFT UP ON THE YELLOW RECOVERY TANK FILTER TO REMOVE IT FROM THE TANK.
|
| 6 |
|
REMOVE THE TANK LID HINGE PIN.
| Wrench-Allen metric 6.0mm |
|
|
| 7 |
|
PULL THE DRAIN HOSE TO REMOVE FROM THE TANK SLOT.
|
| 8 |
|
LOOSEN THE HOSE CLAMP TO REMOVE THE DRAIN HOSE.
| Screwdriver-flat tip |
|
|
| 9 |
|
LOOSEN THE HOSE CLAMPS ON THE VAC HOSES TO REMOVE THEM FROM THE MACHINE.
| Screwdriver-flat tip |
|
|
| 10 |
|
LOCATE THE MACHINE TOOL THAT WAS ATTACHED TO THE KEY RING OF YOUR MACHINE. THIS TOOL WILL BE USED TO OPEN THE MACHINE. IF YOU DO NOT HAVE THIS TOOL, YOU CAN USE A LONG FLAT TIP SCREWDRIVER.
|
| 11 |
|
LOCATE THE LABEL ON THE LEFT SIDE OF MACHINE (STANDING IN OPERATOR POSITION). FOLLOW THE DIRECTIONS ON THE LABEL TO OPEN THE MACHINE.
|
| 12 |
|
FOLLOWING THE DIRECTIONS ON THE LABEL, INSERT THE MACHINE TOOL INTO THE MACHINE.
|
| 13 |
|
LOCATE THE WIRES THAT RUN THRU THE TANK. THESE ARE LOCATED IN THE BATTERY COMPARTMENT.
|
| 14 |
|
LOOSEN THE HOSE CLAMP ON SOLUTION LINE.
| Screwdriver-flat tip |
|
|
| 15 |
|
REMOVE THE 2 SCREWS ON WIRE ASSEMBLY. PULL THE WIRES FROM UNDER TANK TO REMOVE THEM FROM THE MACHINE.
| Screwdriver-phillips |
|
|
| 16 |
|
REMOVE THE 2 BOLTS HOLDING THE TANK TO THE FRAME.
| Wrench-Allen metric 6.0mm |
|
|
| 17 |
|
PULL THE TANK TO REMOVE IT FROM THE FRAME. REMOVE THE 2 SCREWS FROM EACH MUD FLAP ON THE TANK.
| Screwdriver-flat tip |
|
|
| 18 |
|
REVERSE STEPS 2 THRU 17 TO INSTALL A NEW TANK.
|